来源：www.egjd.net 作者：分板机 发布时间：2020-09-03 13:46 浏览量：0
Plate splitter solves the problem of 6 mm light bar without deformation
This machine adopts a unique multi or even more cutting method, through cutting eight pieces of complete plate, two up and down into a group, in order to form a cutting unit. They are group A, B, C, D. The whole cutting process is divided into four stages: a group of blades cut 30% of the circuit board from slot a, and then the re cutting blade B completes 30% of the cutting amount again while the blade is still running, and then it is selected again from the B blade tank which has been rolled, the cutting blade (c) completes 30% of the reduction again, and finally, the final cutting blade and wiper of group D are 10% The stress is more traditional cutting method to reduce more than 80%, which is produced in the cutting process. The edge of the board is better, the edge is smooth, and the board is very smooth without distortion and warping. At present, only after cutting the aluminum-plastic plate to ensure that the machine does not deform.
For the sake of multiple cutting, the cutting process is very smooth, which greatly improves the targeting ability of V-CUT groove. Even if the V-CUT is very shallow, it will not jump out from the V-CUT cutter of the guide groove, so as to avoid bad performance.
As a result of the high-speed steel blade imported from Sweden, the blade life can be greatly enhanced when cutting.
After the first cutter is cut accurately, the laser cutter can continue to cut through all the cutting slots of the laser cutter. It is suggested that the run out is not more than 0.02mm. Ensure perfect cutting quality.